There are two elements that require occasional lubrication to ensure continued smooth running of the FY500: the transmission and the bearing runners.
Important! Before beginning maintenance, disconnect all power
Transmission
The transmission is the toothed rack and pinion gear on the motor. We recommend using WURTH Adhesive lubricant HHS 2000® (Amazon Link)
Place the FY500 on it’s side, with the panel facing upwards. We suggest on an old towel that you do not mind getting oily, or a wipe-clean surface.
To lubricate the transmission, gently pull the slide to the fully extended position. The aim is to spray only the rack area marked green below.

You can use a piece of cardboard to cover the areas around the toothed rack while you spray to shield them. Do not spray towards the red area where the motor and sensors are.
You should not need to lubricate the motor’s pinion gear - enough lubricant from the rack will track back onto the motor gear when the machine is in use.
Bearing Runners
The bearing runners guide the slide as it moves back and forth. We recommend using White Lightning Crystal Grease (Amazon Link) Again, fully extend the slide. There are two runners, one on the top and one on the side. Each runner has 4 bearing surfaces to grease, so a total of 8. Spread a small amount of grease into the groves on the sides of each rail inner and outer components – marked with the green lines below:

If you would like any further assistance, please contact support:
https://fuckyeah.uk/support